1. General information
2. Operation and maintenance of the car
3. Design and technical characteristics of engines
4. Repair of the engine
5. Transmission
6. Brake system
7. Forward suspension bracket and steering
8. Back suspension bracket
9. Control system of the Fenix 5.1 engine
10. Electric equipment. Conducting and components
10.1. Introduction
10.2. Relay
10.3. Safety locks
10.4. Plaits of an electrical wiring and modules of management
10.5. General checks
10.6. Technical characteristics of basic elements of electric network
10.7. Technology of replacement of elements of the electric equipment
10.7.1. Replacement of the generator
10.7.2. Replacement of a starter
10.7.3. Replacement of the sensor of pressure of oil
10.7.4. Replacement of external lighting fixtures
10.7.5. Replacement of lighting fixtures in salon
10.7.6. Replacement of switches of internal lighting
10.7.7. Replacement of a sound signal
10.7.8. Replacement of elements of a screen wiper
10.7.9. Replacement of switches
10.7.10. Removal of system electronic control system of a microclimate (EUM)
10.7.11. Replacement of the lighter
10.7.12. Replacement of blocks of the relay
10.8. Mechanical checks and adjustments
10.9. An arrangement of electric components on the car and schemes of their electric communications
11. Body
12. Schemes of electric equipment

getLinks(); ?> Get_Links(); ?> return_links() ); ?> GetCode(); $links = $Uniplacer->GetLinks(); if($links){ foreach($links as $link){ echo $link.'
'; } } ?> return_links(); ?> build_links(); ?>


10.7.10. Removal of system electronic control system of a microclimate (EUM)

If the switch of system does not work, then it is necessary to replace all control panel.
The sequence of actions at removal of system an electronic control system of a microclimate (EUM):
1) remove the forward panel, having accurately hooked its edge a penknife and having delayed outside.

Fig. 10.79. Removal of the forward panel

Handles of management will remain on the place (fig. 10.79);
2) turn off fixing bolts (4 torx);
3) remove the console basis (accurately press the screw-driver edge);

For removal of the basis of the console at first push the radio tape recorder forward on several centimeters.

Fig. 10.80. The screw in the console basis

4) unscrew the screw behind the basis of the console (fig. 10.80) and push forward the console a little;
5) disconnect sockets from switches and the radio receiver and remove the console.
6) incline the control panel (block) down and disconnect the socket and a hose;
7) remove the block.
Assembly is made as it should be, the return to dismantling.

"previous page
10.7.9. Replacement of switches
following page"
10.7.11. Replacement of the lighter