S40/V40
1. General information
2. Operation and maintenance of the car
3. Design and technical characteristics of engines
4. Repair of the engine
5. Transmission
6. Brake system
7. Forward suspension bracket and steering
8. Back suspension bracket
8.1. General information
8.2. Maintenance and repair
8.2.1. Check and adjustment of angles of installation of wheels
8.2.2. Replacement of the top draft
8.2.3. Replacement of draft of control of a convergence
8.2.4. Removal of the lower lever
8.2.5. Replacement of the rubber plug of the lower lever
8.2.6. Installation of the lower lever
8.2.7. Replacement of the forward rubber plug of the longitudinal lever
8.2.8. Replacement of the longitudinal lever
8.2.9. Replacement of a spring of a back wheel and shock-absorber
8.2.10. Replacement of the stabilizer of cross stability
9. Control system of the Fenix 5.1 engine
10. Electric equipment. Conducting and components
11. Body
12. Schemes of electric equipment
 



13c91ae0




8-2-7-zamena-perednejj-rezinovojj-vtulki-prodolnogo-rychaga.html

8.2.7. Replacement of the forward rubber plug of the longitudinal lever

For removal of the plug execute the following operations:

Fig. 8.13. Preparatory work for replacement of the plug of the longitudinal lever: 1 — a mudguard;
2 — a bolt; 3 — an arm


— remove a mudguard of 1 (fig. 8.13) of an arm 3 cables of the parking brake;
— establish a support under a body, but so that the wheel was not released;
— disconnect draft of control of a convergence from the longitudinal lever, turn out a bolt 2 of the forward rubber plug, delay the longitudinal lever down and record;

Fig. 8.14. Use of the special tool 999 5575 for replacement of the forward rubber plug


— mount a sleeve of 999 5632 (fig. 8.14) and the screw 999 5589 on the special tool 999 5575;
— insert the screw into the rubber plug, put a sleeve 999 5632-2 and tighten a nut;
— to a vypressuyta the rubber plug also remove it from the special tool;
— clear the longitudinal lever;
— cover the rubber plug with assembly lubricant 1161006-0;
— install the special tool 999 5632 over the screw 999 5589;
— install the screw and the new rubber plug, be convinced of correctness of its installation;
— install the rubber plug in the special tool 999 5632 outside, tighten a nut fingers;
— press the rubber plug in the longitudinal lever against the stop;
— remove the special tool;
— be convinced that the rubber plug acts equally from each party;
— lift the longitudinal lever and put a bolt 2 (see fig. 8.13);
— mount draft of control of a convergence on the longitudinal lever. Tighten a bolt the moment of 35 N · m;
— remove a support and several times rock the car up-down;
— tighten a bolt the moment of 90 N · m;
— put an arm of a cable of the parking brake, to tighten four bolts the moment
21 N · m;
— put a mudguard, to tighten a bolt the moment of 15 N · m.

"previous page
8.2.6. Installation of the lower lever
following page"
8.2.8. Replacement of the longitudinal lever