S40/V40
1. General information
2. Operation and maintenance of the car
3. Design and technical characteristics of engines
4. Repair of the engine
5. Transmission
6. Brake system
7. Forward suspension bracket and steering
8. Back suspension bracket
8.1. General information
8.2. Maintenance and repair
8.2.1. Check and adjustment of angles of installation of wheels
8.2.2. Replacement of the top draft
8.2.3. Replacement of draft of control of a convergence
8.2.4. Removal of the lower lever
8.2.5. Replacement of the rubber plug of the lower lever
8.2.6. Installation of the lower lever
8.2.7. Replacement of the forward rubber plug of the longitudinal lever
8.2.8. Replacement of the longitudinal lever
8.2.9. Replacement of a spring of a back wheel and shock-absorber
8.2.10. Replacement of the stabilizer of cross stability
9. Control system of the Fenix 5.1 engine
10. Electric equipment. Conducting and components
11. Body
12. Schemes of electric equipment
 



13c91ae0




8-2-6-ustanovka-nizhnego-rychaga.html

8.2.6. Installation of the lower lever

At installation of the lower lever it is necessary to perform works in such sequence:

Fig. 8.9. Bolts of fastening of the lower lever of a suspension bracket: 1 — a bolt of fastening of the lower lever to a body; 2 — a support; 3 — a bolt of fastening of the shock-absorber; 4 — a bolt of fastening of the lower lever to the longitudinal lever; 5 — a bolt of fastening of a bar of the stabilizer to the lower lever


— mount the lower lever from a body by means of an adjusting bolt 1 (see fig. 8.9);
— put a bolt of the longitudinal lever;
— delay a suspension bracket of a wheel down and put a shock-absorber bolt;
— put nuts and tighten them fingers;
— check purity of surfaces of contact of a brake disk and nave. Grease the central directing pin in a forward part of a nave with anticorrosive structure 1161038-3. Put a wheel and slightly tighten bolts, then tighten them on diagonal the moment of 110 N · m.

       PREVENTION
It is important to carry out an inhaling on diagonal, putting the specified moment. It will prevent formation of tension in a brake disk.

— put a nave cover;
— remove a support and several times rock the car up-down;

Fig. 8.12. Values of the moments of an inhaling of bolts of fastening of the lower lever


— put an adjusting bolt in former position (fig. 8.12);
— tighten bolts the next moments: a bolt of fastening of the longitudinal lever the moment of 90 N · m, a bolt of fastening of the shock-absorber the moment of 80 N · m, a fastening bolt on a body the moment of 80 N · m.
— mount the stabilizer of cross stability on the lower lever, tighten a bolt the moment of 45 N · m;
— check and if necessary adjust the angles of installation of wheels.

"previous page
8.2.5. Replacement of the rubber plug of the lower lever
following page"
8.2.7. Replacement of the forward rubber plug of the longitudinal lever