S40/V40
1. General information
2. Operation and maintenance of the car
3. Design and technical characteristics of engines
4. Repair of the engine
5. Transmission
6. Brake system
7. Forward suspension bracket and steering
8. Back suspension bracket
8.1. General information
8.2. Maintenance and repair
8.2.1. Check and adjustment of angles of installation of wheels
8.2.2. Replacement of the top draft
8.2.3. Replacement of draft of control of a convergence
8.2.4. Removal of the lower lever
8.2.5. Replacement of the rubber plug of the lower lever
8.2.6. Installation of the lower lever
8.2.7. Replacement of the forward rubber plug of the longitudinal lever
8.2.8. Replacement of the longitudinal lever
8.2.9. Replacement of a spring of a back wheel and shock-absorber
8.2.10. Replacement of the stabilizer of cross stability
9. Control system of the Fenix 5.1 engine
10. Electric equipment. Conducting and components
11. Body
12. Schemes of electric equipment
 



13c91ae0 аренда вышка




8-2-3-zamena-tyagi-kontrolya-skhozhdeniya.html

8.2.3. Replacement of draft of control of a convergence

The rubber plugs of draft of control of a convergence which are not replaced. In case of their wear it is necessary to replace draft of control of a convergence assembled for what execute the following operations:

Fig. 8.8. Bolts of fastening of thirst of control of a convergence for a body (1) and longitudinal lever (2)


— mark the provision of an adjusting bolt of 1 (fig. 8.8);
— turn out two bolts 2 longitudinal levers and an adjusting bolt from a body;
— remove draft of control of a convergence;
— mount draft of control of a convergence on the longitudinal lever and tighten bolts the 2nd moment of 35 N · m;
— substitute a support under draft of control of a convergence, wrap a bolt 1 from a body;
— turn an adjusting bolt in former situation;
— remove a support and several times rock the car up-down;
— tighten a nut of an adjusting bolt the moment of 80 N · m;
— check and if necessary adjust the angles of installation of wheels.

"previous page
8.2.2. Replacement of the top draft
following page"
8.2.4. Removal of the lower lever