S40/V40
1. General information
2. Operation and maintenance of the car
3. Design and technical characteristics of engines
4. Repair of the engine
5. Transmission
6. Brake system
6.1. General information
6.2. Appointment and short description of elements of hydraulic system of a working brake
6.3. Electric system
6.4. Technical characteristics
6.5. Parking brake
6.6. Technological service and repair of the brake system
6.6.1. Replacement of brake shoes of forward wheels
6.6.2. Repair of a support of a brake of a forward wheel
6.6.3. Replacement of brake shoes of back wheels
6.6.4. Repair of a support of a brake of a back wheel
6.6.5. Removal and installation of a tank of brake fluid
6.6.6. Pumping of the brake system
6.6.7. Replacement of brake fluid
6.6.8. Replacement of elements of the drive of the parking brake
6.6.9. Replacement of the main brake cylinder and vacuum amplifier
6.6.10. Replacement of elements of anti-blocking system of brakes (ABS)
6.6.11. Check of a side beating of pulse wheels
6.6.12. Removal and installation of a forward pulse wheel
6.6.13. Replacement of a pulse wheel of the back brake mechanism
7. Forward suspension bracket and steering
8. Back suspension bracket
9. Control system of the Fenix 5.1 engine
10. Electric equipment. Conducting and components
11. Body
12. Schemes of electric equipment
 



13c91ae0




6-6-5-snyatie-i-ustanovka-bachka-tormoznojj-zhidkosti.html

6.6.5. Removal and installation of a tank of brake fluid

Works should be performed in such order:
— clear in a motor compartment of a surface around the main cylinder;
— put cleaning rags around the main cylinder;
— merge brake fluid from a tank;
— remove a protective cover of the holder of the socket.
For cars with the mechanical transmission disconnect the hose feeding the main cylinder of coupling, muffle its opening;

Fig. 6.15. Removal of a tank of brake fluid


— disconnect the socket of the sensor of level of brake fluid in a tank (fig. 6.15);
— take out the fixing pin by means of a 3-mm mandrel;
— removal a tank of brake fluid from the main cylinder;
— remove sealing rings from the main cylinder

       NOTE
The tank of brake fluid can be removed only after extraction of the fixing pin.

— carefully clear a tank and the main cylinder.
— put new sealing rings in the main cylinder:
— install a tank, with strengthening having pressed it on the place (to consider position of the socket of the sensor);
— put the fixing pin;
— connect the socket of the sensor of level of brake fluid (for cars with the mechanical transmission);
— connect the hose feeding the main cylinder of coupling;
— slowly fill a tank with brake fluid, several times slowly squeeze out pedals of a brake and coupling.

"previous page
6.6.4. Repair of a support of a brake of a back wheel
following page"
6.6.6. Pumping of the brake system