S40/V40
1. General information
2. Operation and maintenance of the car
3. Design and technical characteristics of engines
4. Repair of the engine
4.1. Removal of a head of the block of cylinders
4.2. Installation of a head of the block of cylinders
4.3. Removal and installation of support of the engine
4.3.1. Removal and installation of a support of the engine from the distributor
4.3.2. Removal and installation of a support of the engine from the transmission
4.3.3. Removal and installation of a forward support of the engine
4.3.4. Removal and installation of a back support of the engine
4.4. Removal of the engine
4.5. Dismantling and assessment of a condition of details of the engine
4.6. Assembly and installation of the engine
5. Transmission
6. Brake system
7. Forward suspension bracket and steering
8. Back suspension bracket
9. Control system of the Fenix 5.1 engine
10. Electric equipment. Conducting and components
11. Body
12. Schemes of electric equipment
 



13c91ae0




4-3-2-snyatie-i-ustanovka-opory-dvigatelya-so-storony-korobki-peredach.html

4.3.2. Removal and installation of a support of the engine from the transmission

At removal of a support of the engine from the transmission make the following:
— remove the air filter;
— turn off an engine support nut;
— raise the engine so that it was possible to take out a support bolt. When raising the engine use wooden whetstone for protection of the pallet from damages;
— remove a conducting plait bracket from the termination of a wire;
— turn off three nuts and remove an engine support.
You make installation in the return sequence.

Fig. 4.19. Fastening of a support of the engine from the transmission





"previous page
4.3.1. Removal and installation of a support of the engine from the distributor
following page"
4.3.3. Removal and installation of a forward support of the engine