11-5-28-snyatie-pribornojj-paneli-v-sbore.html
11.5.28. Removal of the dashboard assembledAssembled you make removal of the dashboard as follows:
|
Fig. 11.98. Illustration of preparatory operations
|
1) if the radio tape recorder with a code of protection against theft is installed, write down this code (fig. 11.98);
2) switch off ignition;
3) disconnect a negative wire from the rechargeable battery;
|
Fig. 11.99. An arrangement of the removed facing panels from the lower party of a combination of devices
|
4) remove panels from the lower party of the dashboard (fig. 11.99) for what:
— remove the left and right side panels of the console;
— remove the lower panels from the driver and the passenger;
— remove conducting of illumination of a niche for legs;
— open glove office.
— turn out two screws and, turning, take out a ware tray;
— turn out from below two fixing bolts of a steering column;
— let's a steering column fall;
— turn out two screws from a fringing and remove a fringing from percussion caps.
|
Fig. 11.100. Removal of a combination of devices
|
— having turned out three screws of fastening, remove a combination of devices (fig. 11.100) (sockets and a flexible shaft of a speedometer remain in the dashboard);
— wring out clamps and push out a flexible shaft of a speedometer together with the holder forward;
— turn off the plastic holder from a flexible shaft of a speedometer;
— disconnect the right socket (gray);
— remove two brackets of fastening of a plait of conducting;
|
Fig. 11.101. Removal of loudspeakers of the audio system
|
5) remove loudspeakers of the audio system from the dashboard (fig. 11.101) for what:
— release the panel in front;
— remove the sunlight sensor (on the car with electronic control by a microclimate);
— remove loudspeakers of the audio system from the dashboard and disconnect sockets;
|
Fig. 11.102. Removal of the control panel of a heater (on the hand-operated car a microclimate)
|
6) remove the control panel of a heater (fig. 11.102) (on the hand-operated car a microclimate) for what:
— remove handles from axes of switches of a heater (use the small screw-driver);
— remove the forward panel (implant fingers into openings and accurately pull together);
|
Fig. 11.103. Removal of the control panel of a heater (on the car with electronic control by a microclimate)
|
7) remove the control panel of a heater (fig. 11.103) (on the car with electronic control by a microclimate) for what:
— insert the small screw-driver through the top air nozzle and wring out a lock pin;
— accurately delay the panel forward in this corner;
— repeat this operation on the other hand;
— accurately take away the panel at the top corners (if necessary use or the small screw-driver);
— handles remain on the control panel of a heater;
|
Fig. 11.104. Removal of the lower tray of the console
|
— remove fastenings of the control panel of a heater;
— remove the lower tray of the console;
— remove fastening of the console from below;
— having disconnected sockets of switches and the radio receiver, remove the console;
|
Fig. 11.105. Detachment of a cable of control of the air mixer
|
9) disconnect a cable of control of the mixer of air (fig. 11.105) from a heater for what:
— remove a cable cover from the fixing bracket;
— disconnect an internal cable from the lever (press a latch);
|
Fig. 11.106. Detachment of conducting and handle of unlocking of the lock of a cowl
|
10) disconnect conducting and the handle of unlocking of the lock of a cowl (fig. 11.106) for what:
— remove fastening and the handle of unlocking of the lock of a cowl with an arm;
— turn off a fixing nut of the block of safety locks and lower it by several centimeters;
— disconnect four sockets from the block of safety locks;
|
Fig. 11.107. Arrangement of bolts of fastening of the dashboard
|
NOTE
This operation is carried out together.
|
— turn out bolts;
— cover from above a casing of a steering column with fabric for protection against damages;
— having pulled, release and remove the dashboard;
NOTE
Governing bodies of a heater remain in the car.
|
— pass through apertures of a wire and cables of management.
Installation of the dashboard on the car is made as it should be, the return to removal. At installation pay attention to the following operations:
— carefully install the dashboard on the place;
— tighten the top bolts by hand;
— put module bolts on the party of the passenger;
— put other bolts;
— adjust position of the dashboard and tighten bolts the moment of an inhaling of 12 N · m;
After all components are installed and fixed in the car, surely perform the following procedures:
— include ignition;
— connect a negative wire to the rechargeable battery;
— be convinced that the alarm lamp of SRS in a combination of devices does not burn.
PREVENTION
Before connection of a negative wire to the rechargeable battery be convinced that in the car there is nobody.
|
— enter a protective code of the radio receiver;
— adjust hours on the exact time.
|