11.5.16. Replacement of a door of a back
After coloring process a back door anticorrosive structure.
Rearrange all shock-absorbers and caps.
All components need to be dismantled from a back door until it is removed.
Make sure that components and conducting are mounted in such a way that their jingle is excluded. Establish a conducting plait, having used a cord.
Fig. 11.74. Points of connection of a door of a back with a body
Assembled (fig. 11.74)
you make removal of a door of a back as follows:
— partially disconnect internal facing of a roof behind;
— extend a conducting plait from a back door (leave it attached to a roof);
— disconnect a washer hose;
Removal of a door of a back needs to be carried out together.
— turn out bolts from both loops;
— disconnect limiters of its opening from a back door;
— turn out bolts and remove a back door.
You make installation of a door of a back upside-down, taking into account the following remarks:
— grease spherical hinges;
— accurately put a conducting plait cover.
Fig. 11.75. Points of adjustment of provision of a door of a back
Adjustment of provision of a door of a back (fig. 11.75)
can be carried out in two ways:
1) sideways and from above, for what:
— release bolts of fastening of loops to a back door on both sides;
— adjust the provision of a door of a back and tighten bolts the moment of 24 N · m;
2) adjustment of situation is made by installation of laying between a loop and a body.
It is also necessary to adjust shock-absorbers that the door of a back was closed without resistance, and shock-absorbers created the necessary effort.