10-7-12-zamena-blokov-rele.html
10.7.12. Replacement of blocks of the relayReplacement of the integrated block
relay and safety locks
in a motor compartment
The sequence of actions when replacing the integrated block of the relay and safety locks in a motor compartment:
1) disconnect a negative wire of the rechargeable battery;
2) uncover the central electronic block;
|
Fig. 10.82. Arrangement of bolts of fastening of the block
|
3) turn off bolts (2 pieces) from the integrated block of relays/safety locks (fig. 10.82);
4) open the block, having wrung out 9 clamps;
5) lift the block up;
6) collect as it should be, the return to removal.
Replacement of the integrated block
the relay and safety locks in salon
The sequence of actions when replacing the integrated block of the relay and safety locks in salon:
1) disconnect a negative wire of the rechargeable battery;
2) remove the lower cover on the party of the driver and disconnect the lighting lamp socket at a floor;
3) remove the handle of opening of the lock of a cowl;
|
Fig. 10.83. Arrangement of bolts of fastening of the block
|
4) turn off a fixing bolt from below of the united block of relays/safety locks (fig. 10.83);
5) delay the block down and remove all sockets in front and behind;
6) establish as it should be, the return to removal, previously having installed the block of safety locks in deepening of the top part.
Replacement of the integrated block
relay and safety locks
The sequence of actions when replacing the integrated block of the relay and safety locks:
7) disconnect a negative wire of the rechargeable battery;
8) remove the lower cover on the party of the driver and disconnect the lamp socket at a floor;
|
Fig. 10.84. Arrangement of bolts of fastening of the block
|
9) turn off two fixing bolts in the top part of the central block of the relay and remove it (fig. 10.84) down;
10) remove fastening of an immobilizer and move away him aside. For release of conducting take out a yellow clamp in a back part;
11) remove conducting by special adaptation;
NOTE
Sockets in front are distributive tires for different switches.
|
12) collect as it should be, the return to removal.
|